We’re edging closer to being able to paint our new downstairs front door. We’re anxious to get it painted before it gets too cold to paint, plus we don’t want the paint we mixed up to go to waste. When we were trying to color match earlier this year we probably added about $130 of artists acrylic to an already expensive can of paint.
We’re using three hinges for this brute, not vintage but brass re-creations. I did acid-etch them to get rid of some fake antique coating and they look better. To cut the recesses we used a Porter Cable door hinge template kit combined with a compact Makita router, both of which do a fine job. I did the first hinge and then Aimee took over and did the remaining two. Placement of the hinges was 7″ from the bottom, 11″ from the top and one between the other two. We trimmed out the corners of the recesses with hand chisels.
Check out the clamps we used to hold the door upright. Note that the clamp base is only supported at the ends and because of this when the weight of the door presses down the base bends and the two uprights clamp tightly to the door and it’s pretty rock solid, not my idea, I found it on a Youtube video. If I can find the video I’ll add a link. These clamps are super useful.
I’m loving those hinges. Just hope no one steals your door or damages it breaking in.
Have you thought about AI controlled machine gun nests around the property?
Ha ha Aimee would like that, then again so would I
Looking good, cant wait to see it up and painted
Hopefully we will start paint in the next few days 🙂